行業資訊
防水瀝青的施工過程具體怎樣的？
來源：http://m.angelatarot.com/ 日期：2022-11-07
在做防水處理時，很多人都會選取用到濟南瀝青料，這樣可以避免房舍出現漏水現象。接下來為大家介紹防水瀝青的施工過程具體怎樣的？
When doing waterproof treatment, many people will choose to use Jinan asphalt, which can avoid water leakage in buildings. Next, we will introduce the construction process of waterproof asphalt?
1、基層驗收
1. Base course acceptance
(1)施工基層要穩固平坦、從未起砂空殼等現象。基層與女兒墻、突出平面構造的連接處應抹成弧形或鈍角。
(1) The construction base course shall be stable and flat, without sand and empty shell. The junction between the base course and the parapet and the protruding plane structure shall be plastered into an arc or obtuse angle.
(2)基層排水的坡度要合乎設計要求，管道等屋面附屬裝置應提早安裝完畢，水落口周圍應做成略低的凹坑。
(2) The slope of base course drainage shall meet the design requirements. The pipe and other roof accessories shall be installed in advance. A slightly lower pit shall be made around the water outlet.
(3)基層須要維持干燥，不能有水分，否則會影響施工功效。
(3) The base course must be kept dry and free of moisture, otherwise the construction efficiency will be affected.
2、施工準備
2. Construction preparation
(1)工具準備：掃把、料桶、盒尺、剪刀、噴槍、液化氣。
(1) Tools preparation: broom, bucket, box ruler, scissors, spray gun, liquefied gas.
(2)材質打算：改性瀝青防水卷材，粘結劑。
(2) Material plan: modified asphalt waterproof roll, adhesive.
3、施工流程
3. Construction process
(1)基層清理
(1) Base course cleaning
對驗收及格的基層應清掃清潔，掃除障礙。
The base course passing the acceptance shall be cleaned to remove obstacles.
(2)基層粘結劑處理
(2) Treatment of base course adhesive
將粘結劑應滿涂于相符要求的基層表面粘結劑在施工時要求均勻涂刮，并對落水口、管道等部位滿粘粘結劑。
The adhesive shall be fully applied to the base course surface in accordance with the requirements. The adhesive shall be evenly applied during construction, and the drain hole, pipe and other parts shall be fully applied with the adhesive.
(3)敷設卷材
(3) Laying coiled material
鋪設方向根據屋面坡度而定，選項鋪貼方式后，試鋪卷材。在同一平面施工時，根據施工人員、進度等情形確定一次排氈的面積，然后卷氈，方便噴粘。
The paving direction is determined according to the roof slope. After the paving method is selected, try to pave coiled materials. During the construction on the same plane, the area of the first row of felt shall be determined according to the construction personnel, progress and other conditions, and then the felt shall be rolled to facilitate the spraying and bonding.
(4)粘貼卷材
(4) Paste coiled material
排氈完畢，收氈，將粘結劑滿刮于基層。將收放好的卷材以液化氣噴槍熱熔粘貼到防水層面，火力要適量，能充分融解卷材表面，邊噴粘邊磙壓，排盡卷材內空氣，使之互為不錯粘結。卷材搭接處用刮刀刮涂粘結劑，封口。女兒墻凹槽內卷材接頭、落水囗、突出屋面構造處等，都以粘結劑封口。
After the felt is discharged, the felt shall be collected and the adhesive shall be fully scraped on the base course. The collected coiled materials shall be hot melted and pasted to the waterproof layer with a liquefied gas spray gun. The fire power shall be appropriate, which can fully melt the surface of coiled materials, spray and stick while rolling, and exhaust the air inside the coiled materials to make them bond well with each other. The lap joint of coiled material shall be coated with adhesive and sealed with scraper. The coiled material joints in the parapet grooves, water outlets, and projecting roof structures are sealed with adhesives.
防水瀝青的施工過程具體怎樣的？以上就是問題的相關內容了，對此您有什么疑惑就來我們網站http://m.angelatarot.com咨詢！
What is the construction process of waterproof asphalt? The above is the relevant content of the question. If you have any questions, please come to our website http://m.angelatarot.com consulting service
公司地址：濟南市商河縣賈莊鎮民營經濟創業園
公司名稱:永誠廣建公路材料（山東）有限公司 
備案號：